FARSmarterBids
Bid Smarter. Far Smarter.

DSCR

DSCR L58: FLIGHT SAFETY CRITICAL PART - CRITICAL APPLICATION - ITEM DOCUMENTATION REQUIREMENTS

L58       52.217-9G04     FLIGHT SAFETY CRITICAL PART, 
                          CRITICAL APPLICATION, ITEM 
                          DOCUMENTATION REQUIREMENTS 
                          DSCR  (SEP 2002)

    (a)  If an item other than that cited in the 
Procurement Identification Description (PID) is offered 
under provision 52.217-9002, (Sec L), of this solicitation,
this provision specifies the Government's requirements for 
additional documentation needed to evaluate whether the 
offered item meets the requirements for the Critical 
Application Item (CAI) and/or Flight Safety Critical 
Application Part (FSCAP) identified in the PID. The 
guidance herein is also intended to assist offerors in 
determining what documentation is needed to insure an 
adequate and timely evaluation of the source manufacturing 
the item - namely, a source approval request (SAR).  The 
offeror shall determine which category applies.  The 
specified documentation for that category, as well as that 
specified for all categories at subparagraph (b), shall be 
submitted in support of the manufacturing process.

         (1)  CATEGORY I - Manufacturer of the same item 
for the Original Equipment Manufacturer (OEM) or for the 
Department of Defense (DoD).

         (2)  CATEGORY II - Manufacturer of a similar item 
for the OEM or DoD. (A similar item is defined as an item 
whose design, application, operating parameters, material, 
and manufacturing processes are similar to those of the 
item for which source approval is sought.)

         (3)  CATEGORY III - New manufacturer. The exact 
or similar item has not been previously provided to the 
OEM or DoD

    (b)  Requirements for all CATEGORIES in addition to 
the below checklist.

         (1)  Documentation shall be provided stating  if 
the company seeking approval is a nonmanufacturing source 
or the actual manufacturer. If the company seeking approval
is a nonmanufacturing source, the required information 
shall also be submitted on the manufacturer. 

         (2)  Any SAR identified to Boeing Rights Guard 
must comply with the Boeing Rights Guard Agreement.

    (c)  The offeror shall check below the CATEGORY that 
applies and include this part of the provision, as well as
the additional required documentation, in support of the 
source approval request. 

            CATEGORY I (same part)                 [     ]
            CATEGORY II (similar/equivalent part)  [     ]
            CATEGORY III (new manufacturer)        [     ]
		
To determine the mandatory requirements to submit for 
CATEGORY I � III parts, the offeror must go to this website
www.dscr.dla.mil/sarguide.doc.